Repair
313889B 15
Clamp Installation
1. Install engine shaft key (18).
2. Tap clamp (22) onto engine shaft (A). Maintain
dimension of 2.612 ± .010 in. (66.34 ± .25mm).
Chamfer must face engine.
3. Check dimension: Place rigid, straight steel bar (B)
across face of clutch housing (19). Use accurate
measuring device to measure distance between bar
and face of clamp. Adjust clamp as necessary.
Torque two screws (23) to 125 ± 10 in-lb (14 ± 1.1
N•m).
4. Install armature (25) on engine drive shaft.
5. Install four screws (23) and lock washers (24).
Torque to 125 ± 10 in-lb (14 ± 1.1 N•m).
6. Check o-ring (29d) and replace if missing or dam-
aged.
7. Tap pinion shaft (29a) in with plastic mallet.
8. Install retaining ring (29b) with beveled side facing
up.
18
ti13216a
2.612 in.
(66.34 mm)
ti5483a
23
24
25
ti13213a
29d
ti13210a
29a
ti13212a
29b
