Attach the “Y” duct hose adaptor to
the 8 foot front duct hose and
connect both 4 foot hoses from “Y”
to vents in driver and passenger side
front ceiling. This will provide a
total of four ceiling vents.
Route HVAC 2 1/2” blower hoses to
the approximate locations with tape
along ceiling where they will be
installed into the ceiling insert after
Kwik-Kit insert is installed. Mount
hoses with wire ties at wall and ceiling
corners only. Leave enough slack to
reach hoses for permanent mounting.
During Kwik Kit installation you will be
prompted to return to the KK-F-VAK
instruction to attach the hose to the vent
adapter brackets. Route hose into ceiling holes
and cut off any extra slack. Attach the hose to
the vent bracket using a 3” hose clamp
Align the three mount holes of the vent adapter
cover with the pre-punched holes in ceiling.
Attach each vent to ceiling using #8 x 3/8” flat head
sheet metal screws.
(Screws included with standard Kwik kit hardware)
KK-F-VAK_INST_10-08
4
