Configuring IP Addressing
Configuring a Single Source IP Address
The show ip source-interface detail command displays detailed information
about the configured policies, source IP address, and interface state for each
protocol.
Syntax
:
show ip source-interface detail [radius | tacacs | syslog]
Displays detailed operational status information for the
source IP address selection policy. Information about the
configured policies, source IP address and interface state are
displayed.
When no parameters are specified, policy information for all
protocols is displayed.
ProCurve(config)# show ip source-interface detail
Source-IP Detailed Information
Protocol : Tacacs
Admin Policy : Configured IP Interface
Oper Policy : Configured IP Interface
Source IP Interface : vlan 22
Source IP Address : 10.10.10.4
Source Interface State : Up
Protocol : Radius
Admin Policy : Configured IP Address
Oper Policy : Configured IP Address
Source IP Interface : vlan 3
Source IP Address : 10.10.10.2
Source Interface State : Up
Protocol : Syslog
Admin Policy : Configured IP Interface
Oper Policy : Configured IP Interface
Source IP Interface : vlan 10
Source IP Address : 10.10.10.10
Source Interface State : Up
Figure 8-19. Example of Detailed Information Displayed for Each Protocol
The show command can also be used with the application to display the source
IP address selection information in effect for the application protocol.
8-30
