A SERVICE OF

logo

Open as PDF
next previous
Appendix C Printer Memory and Expansion 402
Adjusting Memory Settings
3 Using a software application, download all the fonts you want to use in the
selected language.
4 Print a configuration page (page 278
). The amount of memory used by the
fonts is listed next to the language. Round this figure up to the nearest
100 KB. (For example, if 475 KB are shown, 500 KB should be reserved.)
5 From the Configuration Menu, set PCL MEMORY or PS MEMORY to the value
determined in step 4.
6 Repeat step 3. (You must download all fonts again. See the note below.)
Note When you change the Resource Saving setting, all downloaded resources
(such as fonts or macros) will need to be downloaded again, unless they
are stored on an optional hard disk or flash DIMM.