Transfer Switch
Page 14 of 16 Pages
8.0 Plant Exerciser Timer
Set the time
1) Press the Res. (reset) button to clear the memory
2) Press and hold the (time/run mode) button while setting the time
a) Press the h button to set the hours
b) Press the m button to set the minutes
c) Repeatedly press the Day button to select the day of the week (1—7, Monday–Sunday)
3) When set correctly, the colon between the hours and minutes flashes
4) To reset for daylight savings time
a) Press the ±1h button one time in the spring to advance the time one hour
b) Press ±1h one time in the fall to set the time back one hour
Notes
The time and the day of the week must be set before programming the Timer.
The Timer has sufficient back up power to maintain the time and program settings for up to four days.
Programming
1) To set the Timer to transfer the transfer switch with load or no load once a week and run generator
set for thirty minutes,
Friday at 9:00 a.m.
a) Press the Prog. (program) button to display the day of the week and time setting for the program
b) Press the (ON/OFF) button once to display the ON (open circle) symbol
c) Press h to set the hours until 09 AM is displayed
d) Press m to set the minutes until 00 is displayed
e) Press Day eight times to select 5 (Friday) as the day of the week to run
(Press the button four times to select Monday or up to 10 times to select Sunday.)
f) Press Prog. button
g) Press twice to display the OFF (open circle with dot) symbol
h) Repeat steps c), d), and e) to set 9:30 a.m., Friday
i) Press Prog. button
j) Press the (time/run mode) button
2) To review the programming
a) Press Prog. once to see the transfer time
