11
42624-01 • 12/01/06 Hunter Fan Company
Uninstalling the Light Fixture
1. To uninstall the light fi xture, fi rst disconnect the plug connectors
between the black wire and the black/white wire.
2. Disconnect the plug connectors between the two white
wires.
3. Uninstall the nut and washer from the end of the light fi xture
inside the lower switch housing.
4. Unscrew the threaded rod of the light fi xture from the lower
switch housing.
5. Remove the light fi xture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through fi rst, and then pull the other plug connector
(female) through the hole.
6. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7. Install the switch housing cap and plug button to the lower
switch housing.
8. Continue with step 7-6 on page 12.
Lower Switch
Housing
readed Rod
Steps 3 – 5
Male Dummy
Term inal
Female Dummy
Term inal
Step 7
Cap
Plug Button
