REV: 5/94
MOUNT BLADES TO FAN WITH WOOD PADDLES LOCATED UNDERNEATH BLADE BRACKETS.
UNTIL SOUND HAS DISAPPEARED.
NOTE: SHOULD GLOBE EMIT ANY SOUND WHEN FAN IS RUNNING, RE-ADJUST 3 GLOBE MOUNTING SCREWS
POSITIONED ON THE OPPOSITE SIDE OF THE BLADE IRON. SEE FIG. 8.
VIBRATION OR WOBBLING. BLADES SHOULD BE MOUNTED FLAT AGAINST IRONS, WITH THE BOSSES
BOSSES
BLADE BRACKET
BLADE
BLADE & BLADE BRACKET
SCREWDRIVER
FIGURE 8A.
SCREWS ARE TIGHT
NOTE: MAKE CERTAIN ALL
BLADE MOUNTING SCREWS
HOLES
CLEARANCE
B. WORKING THROUGH THE LARGE CLEARANCE HOLES IN THE LIGHT/SWITCH HOUSING, REMOVE THE SCREWS
SCREWS FROM THE MOTOR HUB. INSERT A MOUNTING SCREW (PROVIDED) IN HOLE IN BLADE BRACKET.
GLASS GLOBE TO THE SWITCH HOUSING BY CAREFULLY TIGHTENING THE (3) SCREWS.
FORM NO. 40987-01
PAGE 4
#8-32 KNURLED HEAD SCREW
HALFWAY INTO THE (3) THREADED HOLES IN THE SIDE OF THE SWITCH HOUSING. SECURE THE
A. INSTALL (2) 60W LIGHT BULBS (NOT INCLUDED). THREAD THE (3) #8-32 KNURLED HEAD SCREWS
GLOBE
SWITCH HOUSING
MOTOR
BULB AND GLOBE INSTALLATION
STEP 9:
STEP 8:
WITH THE KIT.
OPERATION, YOU MAY USE THIS KIT TO CORRECT THE BALANCE PER THE INSTRUCTIONS SUPPLIED
C. A BLADE BALANCING KIT HAS BEEN PROVIDED WITH YOUR FAN. SHOULD THE FAN WOBBLE IN
ROTATING MOTOR HUB AS NEEDED TO EXPOSE MOUNTING HOLES. SEE FIGURES 8A AND 9.
DO NOT TIGHUTEN UNTIL BOTH SCREWS HAVE BEEN PUT IN BLADE BRACKET. REPEAT FOR ALL BLADES,
TURNING SCREW AND READJUSTING BLADE BRACKET UNTIL SREW MATES WITH THREADED HOLE IN HUB.
USE A SCREWDRIVER TO HOLD IN PLACE. ALIGN BLADE HOLES WITH MOUNTING HOLES IN HUB BY
ASSEMBLE THE BLADE TO THE BLADE BRACKET. MAKE SURE ALL SCREWS ARE TIGHT TO PREVENT
A. ATTACH WOOD BLADES TO BLADE BRACKETS USING THREE SCREWS FOR EACH BLADE. SEE FIGURE 8.
FAN BLADE ASSEMBLY, INSTALLATION, AND BALANCING
FIGURE 9.
FIGURE 8.
PULL CHAIN SWITCH
BREAKAWAY CONNECTOR
PURCHASED ACCESSORY CHAIN
REVERSING SWITCH
(IF DESIRED)
