Invacare Adjustable ASBA Seat Manual

A SERVICE OF

next previous

SECTION 6—FRONT RIGGINGS

Part No 1143238 27 Adjustable ASBA Seat

CAUTION

Make sure coved spacers are positioned properly when reassembling to prevent

damage to the frame mounting tubes.

6. Reinstallthefootrest(s)ontothewheelchair.RefertoInstalling/RemovingFootrestson

page 24.

7. Reinstallanyaccessoryontothefootrest(s).

Replacing Heel Loops

NOTE:Forthisprocedure,refertoFIGURE 6.6.

1. Notethepositionofhexbolt,covedwashersandlocknutforreinstallation.

2. Removethehexbolt,covedwashersandlocknutthatsecurethelowerfootresttothe

footrestsupport.

3. Removethelowerfootrest.

4. Removethephillipsbolt,spacerand

locknutthatsecuretheheelloopto

the

lowerfootrest.

5. Slidetheheelloopoffthelower

footrest.

6. Replaceheelloop.

7. ReverseSTEPS1‐6toreassemble.

NOTE:Whensecuringheellooptolower

footrest,tightenthephillipsboltandlocknut

untilthespacerissecure.

FIGURE 6.6 Replacing Heel Loops

Raising/Lowering Elevating Front Riggings

NOTE:Forthisprocedure,refertoFIGURE 6.7.

1. Performoneofthefollowing:

•Raising‐Pullbackontherelease

leverandraisefrontriggingtothe

desiredheight.

•Lowering‐Supportfrontrigging

withonehandawayfromthe

releaselever.Pushreleaselever

downwardwithotherhand.

FIGURE 6.7 Raising/Lowering Elevating

Front Riggings

Footrest Support

Hex Bolt

Phillips Bolt

Spacer

Heel

Loop

Locknut

Lower Footrest

Coved

Washer

Locknut

Release

Lever