TROUBLESHOOTING TIPS
before requesting Service. You may be able to solve the problem yourself.
If you face problems connecting the TV to external devices, please refer to the User Guide of the external device or call their service centers
for help. Charges for TV installation and adjustments of customer controls are not covered under your warranty.
1. SPDIF output audio only in digital mode and the audio equipment used must have the decoder.
2. Monitor Out Audio LR output audio for both analog and digital programs
button on the remote control repeatedly to select the desired AV channels. Note:
AV button on the remote control repeatedly to select the desired AV channels. Note: AV
SVHS can only be selected if a S-VHS device is connected and powered on.
in the television menu and select the correct signal source, then perform the
automatic installation again. (Refer to page 11).
in the television menu and select the correct signal source, then perform the
automatic installation again. (Refer to page 11).
depending on the number of channels that are available.
It is normal to hear a disturbing sound (such as buzzing, clicking, cracking, humming, whistling, etc)
from a distance less than 2 meters (6 feet) with the television sound muted.
If problem occurs on one channel, you may have a signal problem. Please contact the cable provider
or local broadcaster regarding the speciļ¬ c channel.
This could be due to any of the following reasons:
ot all transmitted broadcasts by the cable or broadcast stations are in
with several major network stations to be sure that the station you selected is in
2. When SAP is turned ON, the sound mode is automatically set to MONO.
3. Sound mode is set to MONO. Set the sound mode to STEREO. (Refer to page 19).
4. When using an AV input, the television will not display STEREO even though it is producing
Check the TV power cord. Unplug the power cord from the TV, wait 10 seconds, then reinsert
the plug into your wall outlet. Power On the TV again.
Plug the power cord directly to the wall socket and not via an extension cord.
If you need to use an extension cord, check that
the fuse on the AC power strip is not blown.
the antenna / cable is connected p
and that you have selected the
e could be temporarily no transmission on the selected channel. You may like to add these
channels to the Weak Dig Sig. list. (refer to page 15). When transmission is resumed or when
available, your TV will receive it.
The current channel has only audio transmission.
