Standard Gauges
The following standard gauges are included on all
models except where noted. It is important for the safe
and proper operation of your boat to fully understand
these gauges.
Tachometer
Located top right of the dash panel the tachometer
registers the operating speed of your engine in
revolutions per minute (RPM). This gauge is used to
provide you with information needed to ensure the
operation of the engine is kept within engine
manufacturer’s proper range of operation. Be sure to
consult your engine manual for the correct range of
operation for your particular model.
Do not operate the engine with the tachometer in the red
area. Your engine or other parts could be damaged. Damage
caused to your engine or boat due to operation of the engine
in the red area may not be covered by your engine warranty.
Engine Hourmeter
Located on the bottom center of the tachometer gauge is the engine hourmeter. This meter
will help identify how much your boat is being used and at what time the engine will
require servicing. The hourmeter will run whenever the ignition is on.
The engine hour gauge acts as an odometer for the engine. Engine hours should always be
noted so maintenance and lubricant changes may be performed at proper intervals. Please
refer to your engine manual to determine maintenance schedules.
Speedometer
This gauge registers the speed of the boat in miles per
hour (MPH). To adjust the speedometer gauges, locate
the speedometer adjustment switch located on the
center bottom panel of the of the dash. The
speedometer adjustment is the left-hand button. The
right-hand button is the speedometer pick-up selection
and will regulate which speedometer is being used
should one of your speedometer pickup tubes become
clogged with debris.
Caution
2-2
Figure 2-4. Speedometer
Figure 2-3. Tachometer/Hourmeter
®
