11
!1 PRE OUT Button
This button turns output from the PRE OUT jack on the
rear panel ON and OFF. When output is ON, the center of
the button is lit a blue color.
!2 REC OUT Button
This button turns the signals output from the RECORDER
1 and 2 OUT jacks on the rear panel ON and OFF. When
output is ON, the center of the button is lit a blue color. For
instructions on how to record, see “RECORDING” on pg.
16.
When RECORDER 1 is selected as the input source, sig-
nals are not output to the RECORDER 1 OUT jack. The
same goes for the RECORDER 2 OUT jack when RE-
CORDER 2 is selected as the input source.
!3 PHONO MC Button
This button switches the phono equalizer between MC and
MM. When MC is set, the center of the button is lit a blue
color. Set the phono equalizer amplifier according to the
type of cartridge you use.
!4 Side Illumination
The side illumination casts a blue light over switches and
buttons. It can be turned ON and OFF from the DISPLAY
button. For instructions on how to operate the side illumi-
nation, see “HOW TO OPERATE THE SIDE ILLUMINA-
TION” on pg. 18.
NAMES AND FUNCTIONS OF PARTS
DISPLAY
!5 Power Indicator
This indicator is lit a blue color while power to the PM-
11S1 is ON.
!6 Display Panel
Approximately 3 seconds after power
to the PM-11S1 is activated, the ID
set for the PM-11S1 is displayed here.
After that, the top line displays the in-
put source selected with either the IN-
PUT SELECTOR knob or the remote
controller, while the bottom line dis-
plays the volume level set with the
VOLUME knob or the remote control-
ler. When the PM-11S1 I is first activated, the attenuation
level (dB) is displayed for the initial volume level.
Volume Level Indication
The display panel also displays left-right level balance and
tone control trimming level. For instructions on how to ad-
just bass and treble, see “How to Trim Bass” and “How to
Trim Treble” on pg. 20.
The display panel also displays messages in response to
PM-11S1 operation.
!7 OPERATE Indicator
This indicator indicates the operating status of the PM-
11S1. When the ID is set to “0” for standalone operation, it
is lit a red color. When multiple PM-11S1s are connected
by FCBS, only the OPERATE indicator of the master PM-
11S1 (ID 1) lights a red color. Slave PM-11S1s whose
OPERATE indicator does not light a red color cannot be
used to operate other units in sync. For more information
on the FCBS, see “ABOUT FCBS” on pg. 17.
Also, the OPERATE indicator flashes if a protective circuit
trips. For troubleshooting procedures, see “TROUBLE-
SHOOTING” on pg. 22.
Max
0.5 dB steps
Min
Turn the VOLUME knob on
the PM-11S1 to the right or
press the VOLUME 3 button
on the remote controller.
Turn the VOLUME knob on
the PM-11S1 to the left or
press the VOLUME 4 button
on the remote controller.
04.8.17, 11:36 PMPage 11
