MICROBOARDS TECHNOLOGY, LLC GX AUTO PRINTER
15
Ink Tab
The Ink Levels show how much
remains of all 3 colors, Cyan,
Magenta and Yellow.
NOTE: If you place a used
cartridge in the GX Auto Printer,
the ink level may not be reported
correctly. If the GX Auto Printer
can identify the cartridge, it may
report the correct ink levels; if
not, it will assume that the ink
cartridge is new and will show
ink levels of 100%.
Before each disc is printed, the ink levels are checked. If the level of any one color is has reached
10%, a warning message will be displayed on your PC and printing will be temporarily suspended.
You can either change the cartridge at this point and click OK, or click OK to continue printing using
the same cartridge.
If you continue with the same cartridge, printing will continue uninterrupted until the ink level reaches
5%. The low ink level warning will be displayed once more. Again, either change the cartridge or
continue.
Once the ink level reaches 3% or less, the warning will be displayed before each print.
It is strongly recommended that you replace the cartridge at this point.
The Ink Cartridge information includes the re-order part number for the cartridge.
Alignment Tab
Alignment values will move the print
image on the disc. Use the graphic on the
right side of the tab as a guideline in how
alignment values should be adjusted.
The Resolution setting should always be
set at .1mm for best results.
The Outer and Inner Diameters will
change the size of the area to be printed.
To avoid excessive ink buildup, these
values should never be set so that the GX
Auto Printer is printing off the media.
The default diameter settings are 1180 for
the Outer and 360 for the Inner when the
resolution is at .1mm. For hub-printable
media, the Inner diameter should be
reduced.
About Tab
The About tab provides you with contact information for the worldwide Microboards offices.
