11
WARNING
4
Mounting The
Undercarriage Assembly
1. Remove and retain the four hairpin clips from the
weld pins found on the top side of the undercarriage
assembly. Remove and retain the two clevis pins with
hairpin clips. This hardware is for later installation.
See Fig. 4-5.
2. With the undercarriage assembly beneath the tractor,
see Fig. 4-6, lift the undercarriage assembly up
against the frame of the tractor. The weldpins on the
top of the undercarriage assembly should go through
the aligning holes found along the tractor’s frame.
See Fig. 4-7.
3. Fasten the undercarriage assembly to the frame with
the hairpin clips removed in step 1. See Fig. 4-8
4. Route the upper drive belt around the engine pulley.
See Fig. 4-7.
NOTE: Proceed to the Assembling Controls section of
this manual if you have an Electric PTO.
5. Attach the extension spring to the idler pulley. See Fig.
4-9. Connect the other end to tractor’s frame rail. See
Fig. 4-10.
Figure 4-5
Figure 4-6
Figure 4-7
Figure 4-8
Figure 4-9
Figure 4-10
Before installing
attachment, place
tractor on a firm
and level surface.
Place the PTO in
the disengaged
(OFF) position, set
the parking brake,
shut engine off and
remove key to prevent
unintended starting.
Assembly
& Attaching
Undercarriage
