2. While the indicator light for the memory
switch being set is illuminated for 5 sec-
onds, press the button on the keyfob.
The indicator light will blink. After the indica-
tor light goes off, the keyfob is linked to that
memory setting.
With the key removed from the ignition switch,
press the
button on the keyfob. The driv-
er’s seat, accelerator and brake pedals, and out-
side mirrors will move to the memorized position.
NOTE:
If a new memory position is saved to the
memory switch, the keyfob automatically
re-links.
Confirming memory storage
● Turn the ignition switch ON and push the
SET switch.If themain memoryhas notbeen
stored, the indicator light will come on for
approximately 0.5 seconds. When the
memory has stored the position, the indica-
tor light will stay on for approximately 5 sec-
onds.
● If the battery cable is disconnected, or if the
fuse opens,the memory storagefunction will
be canceled and must be restarted before a
stored memory position can be set again.
Drive the vehicle over 25 MPH (40 km/h) to
restart the memory storage function. You
can alsorestart the memorystorage function
using the following procedure.
1. Connect the battery cable or replace the
fuse.
2. Open and close the driver’s door more than
two times with the ignition switch in the
LOCK position.
Once thememory storagefunction hasbeen
restarted, you can store a memory position.
See “Memorystorage function”earlier inthis
section.
Selecting the memorized position
Set the shift selector to the P (Park) position,
then:
● Within 45 seconds of opening the driver’s
door, push the memory switch (1 or 2) or
● Turn the ignition switch to the ON position
and push the memory switch (1 or 2).
The driver’s seat, accelerator and brake pedals,
and outside mirrors will move to the memorized
position with the indicator light blinking, and then
the light will stay on for approximately 5 seconds.
ENTRY/EXIT FUNCTION
This system is designed so that the driver’s seat
will automatically move when the shift selector is
in the P (Park) position. This allows the driver to
get into and out of the driver’s seat more easily.
The driver’s seat will slide backward:
● When the key is removed from the ignition
switch and the driver’s door is opened.
● When the driver’s door is opened with the
key turned to LOCK.
● When the key is turned from ACC to LOCK
with the driver’s door open.
The driver’s seat will return to previous position:
● When the key is inserted into the ignition
switch and the driver’s door is closed.
● When thedriver’s dooris closedwith thekey
turned to LOCK.
● When the key is turned from ACC to ON
while the shift selector is in the P (Park)
position.
Pre-driving checks and adjustments 3-27
੬ REVIEW COPY—
2009 Quest (van)
Owners Manual—USA_English (nna)
07/17/08—debbie
੭
