Norcold 442 Manual

A SERVICE OF

next previous

4 Remove the lower door b

y

openin

g

it sli

g

htl

y

and pullin

g

the top of the door awa

y

from the

refri

g

erator. Allow enou

g

h room so the door

can be lifted up and off of the bottom hin

g

e pin

shoulder

(

See Fi

g

ure 18

)

. Be sure to save the

hin

g

e plates alon

g

with the spacer used in the

middle hin

g

e bracket, for reassembl

y

later.

(

See Fi

g

ures 19A, 19B, and 19C

)

REMOVING AND RELOCATING THE HINGE

BRACKETS

5. Remove the middle hin

g

e bracket b

y

usin

g

the

#2 Phillips screwdriver and takin

g

out the three

screws holdin

g

it in place. Next, remove the

three screws on the opposite side correspond-

in

g

to the center hin

g

e location. Relocate them

in the holes

j

ust exposed b

y

the removal of the

hin

g

e bracket. Attach the hin

g

e bracket to the

refri

g

erator on the opposite side. Do not ti

g

hten

screws completel

y

.

(

See Fi

g

ure 15

)

6. Remove the top hin

g

e bracket and reposition it

in the opposite bottom corner. Use the same

techni

q

ue as outlined in Step #5.

7. Remove the bottom hin

g

e bracket and reposi-

tion it in the opposite top corner. Use the same

techni

q

ue as outlined in Step #5.

RELOCATING THE TRAVEL LATCHES

8. Remove both travel latches b

y

takin

g

out the

two screws holdin

g

each to the refri

g

erator.

Use the #2 Phillips screwdriver. Remove the

two screws from each of the correspondin

g

holes on the opposite side of the refri

g

erator.

Relocate them in the two holes

j

ust exposed b

y

the removal of the latches. Attach the latch in

the new position so the tab points towards the

opposite side of the refri

g

erator. Do not ti

g

hten

screws completel

y

.

(

See Fi

g

ure 16

)

9. Turn the door over so that the end previousl

y

at the bottom is now at the top. Relocate the

bottom of the door on the bottom hin

g

e pin

shoulder. Close door and ali

g

n holes in top

hin

g

e brackets. The ma

g

netic

g

asket will hold

the door in place. Before reinstallin

g

the top

door, check to insure that the spacer is in

place.

(

See Fi

g

ures 17 and 19C

)

10. Reposition the upper door in a similar manner

as described in Step #9, except the top of the

door must be en

g

a

g

ed into the hin

g

e pin

shoulder before settin

g

the door in place.

(

See Fi

g

ure 18

)

11. Startin

g

at the top, replace the hin

g

e pins usin

g

the slotted screwdrivers. Ti

g

hten all screws.

Fi

g

ure 14

Fi

g

ure 15

Fi

g

ure 16

Fi

g

ure 17

12