SPECIAL MODES
5-22
Transparency film with insert sheets
When copying onto transparency film, blank insert sheets can be placed between transparent sheets.
●
This function only operates in "one-sided to one-
sided" and "two-sided to one-sided" modes.
● Multiple copies cannot be selected in this mode.
●
The inserts are inserted under each transparency
as shown at left.
●
Select insert paper that is the same size as the
transparencies.
● Transparencies can be fed from the tray 2 or
bypass tray.
●
If the transparencies are loaded in tray 2, be sure
to set the paper size and paper type as explained
on pages 2-5 and 2-6.
1
Load transparency film into the tray 2.
Remove any paper
already in the tray 2
before loading the
transparency film. (To
load paper in the tray 2,
see pages 2-6 and 2-7.)
2
Press the [CUSTOM SETTINGS] key.
The custom settings
menu screen will
appear.
3
Touch the [PAPER TRAY SETTINGS] key.
The paper tray selection
screen will appear.
4
Touch the [TRAY SETTINGS] key.
5
Touch the key to display the tray
settings screen of tray 2.
6
Touch the [TYPE/SIZE] key.
7
Touch the [TRANSPARENCY] key.
8
Touch the [OK] key.
If the paper size was changed from an AB size to an
inch size, or from an inch size to an AB size, be sure
to set the paper type and size as explained on steps
5 to 6 on page
2-5
and steps 7 to 10 on page
2-6
.
Insert sheets
Example: Inserting insert sheets between transparencies
Originals (1-sided)
Originals (2-sided)
Two-sided originals are only
supported when automatic
document feeder is used.
Inserts can also be
copied on.
