81
ENGLISH
81
Machine actions Causes Solutions
The co ee is too weak (see
note).
This might occur when the machine
is automatically adjusting the dose.
Brew a few co ees as described in chap-
ter “Saeco Adapting System”.
The ground co ee is too coarse. Change co ee blend or adjust the grind
as explained in the “Adjusting the Ceramic
Co ee Grinder” chapter.
Co ee is brewed slowly (see
note).
The ground co ee is too ne. Change co ee blend or adjust the grind
as explained in the “Adjusting the Ceramic
Co ee Grinder” chapter.
Circuits clogged. Perform a descaling cycle.
The brew group is dirty. Clean the brew group (see the “Weekly
Cleaning of the Brew Group” chapter).
Co ee leaks out of the
dispensing spout.
The dispensing spout is clogged or
not correctly inserted.
Clean the dispensing spout and its holes
and insert it back correctly.
Note:
these problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case wait until
the machine performs a self-adjusting operation as described in the “Saeco
Adapting System” chapter.
