EN
13
Problem Possible cause Solution
POWER light (A-6, B-9) Unit not switched on. Press On/Off button (A-1) or
does not light. set On/Off switch (B-8) to ON.
AC power adapter (A-3, B-5) Connect AC power adapter
not connected to the (A-3,B-5) to the DC 9V
——<<++
DC 9V
——<<++
power supply power supply jack (A-2, B-4).
jack (A-2, B-4).
AC power adapter (A-3, B-5) Connect AC power adapter (A-3,
not connected to the power B-5) to a wall outlet.
supply.
Batteries low. Replace batteries.
POWER light (A-6, B-9) Batteries low. Replace batteries.
is blinking.
High pitched noise. Units too close to each other. Move parent unit away from baby
unit (at least 1 metre / 3 feet).
Volume set too high. Turn ON/OFF switch /
VOLUME control (B-8) upwards.
Pick-up from another Both systems are operating Switch channels (A-8, B-7).
baby monitor. on the same frequency. Make sure both units are set
to the same position.
LINK light (B-3) Units are out of range. Move units closer together.
flashing red / LINK
alarm beeps. Interference from another Switch to a different channel
baby monitor. (A-8, B-7).
Interference from another Remove other FM source.
FM source.
Troubleshooting
