6
Inserting the batteries into
the remote control
!
Remove the battery holder from the back of the
remote control.
To do this, squeeze the holder at the lateral marks
(1.) and pull it off (2.).
"
Insert the batteries as indicated in the battery
holder.
ยค
Close the battery holder by sliding it into the
remote control until you hear a "click".
Connecting to the aerial
Your video recorder could actually be referred to as a
"TV set without picture screen".
This is why you have to connect it to an aerial as well
as to a TV set. Only then you can make recordings and
play cassettes.
Note:
* So that the remote control operates correctly, it
must always be pointed at the TV set.
!
Remove the aerial cable plug from the TV set and
insert it into the 3 socket at the rear of the
video recorder.
"
Use the aerial cable supplied to connect the 4
socket on the video recorder with the aerial input
socket on your TV set.
Connecting to the TV set
If your TV set does not have a Scart socket, do not
read here but continue with chapter "Additional
functions of your video recorder". In the chapter
"Playback via the aerial cable" you will find the required
information.
!
Insert one plug of the Scart cable supplied into the
Scart socket yx on the back
panel of the video recorder. Insert the other plug of
the Scart cable into the Scart socket on the TV set.
"
Many TV sets automatically switch over to the
programme position "EXT" (External) or "AV"
(Audio/Video) with the help of this cable
connection when playback is started on the video
recorder.
For other TV sets, select the programme position
"EXT", "0" or "AV" for video playback manually on the
TV set. How this is done is to be found in the operating
instructions of the TV set.
Notes:
* If your TV set has several Scart sockets, select
the socket which has a video input and output
function.
* If your TV set allows for selecting the video sour-
ce via a menu, select "TV" as source for this Scart
socket.
