Chapter 3 Changing the Library Configuration
Changing the Terminator Power Setting
58 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
Changing the Terminator Power Setting 3
The
Terminator Power option controls whether the library robotics
provide terminator power.
To enable or disable robotics terminator power:
1 Access the Configuration screen (see Accessing the
Configuration Screen).
2 Press the Up or Down buttons until Terminator Power is
highlighted.
3 Press Select.
4 Use the Up or Down buttons to select the desired Terminator
Power
setting. Available settings are Enabled and Disabled.
5 Press Select.
To return to the
Configuration screen without changing the
option setting, press
Cancel.
6 Press Main to return to the main screen.
Note: The default setting is Enabled.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.
