A SERVICE OF

logo

SETTING UP
1-11
SETTING UP
TESTING
After you load paper, you can test the machine using the Test menu available
from the Control Panel.
Follow these steps to access the Test menu:
1
Make sure the [ ] and [ ] indicator lights are lit.
2
Press the [ ] key so the [ ] indicator turns off. This indicates you are in
the Menu mode.
3
Press the
[5]
key until “Test/Print” appears on the display, then press the
[
]
key
4
Press the [5] key until “System Config” appears on the display, then press
the [ ] key to print the Configuration Page, listing information about
the machine system and configuration.
5
After printing the page, the printer will return to the On Line mode and display
“Ready”.
6
Check the Configuration Page for your settings.
Refer to the “Using the Control Panel” chapter in this manual for further
information on configuring the machine and testing the printing capabilities.