– Rotary control used to adjust the level of
signal source connected to channel 1.
– When the LED Backlit switch is pressed
in, the switch lights red and the input is assigned to
– When the LED Backlit switch is pressed in,
the switch lights green and the input is assigned to
select either stereo or mono input.
– Convenient area for marking the
input source allowing you to label the channel with
the device connected to the input.
– When the LED Backlit switch is pressed in,
the switch lights amber and the input is assigned to
– When the LED Backlit switch is pressed in,
the switch lights orange and the input is assigned to
– Channel 2 input with the same knob
and switch complement as Channel 1.
– Channel 3 input with the same knob and
switch complement as Channel 1.
– Channel 4 input with the same knob and
switch complement as Channel 1.
– This built-in, miniature super-
speaker allows you to listen to the signal that is pres-
- This rotary control is used
to adjust the monitor level heard in the front panel
Headphone jack or SUPER SPEAKER.
Headphone jack or SUPER SPEAKER.
– This four-position switch is
used to assign any of the four Zones to play in the
MONITOR SPEAKER or HEADPHONE JACK.
- Connect any standard stereo
HEADPHONE JACK - Connect any standard stereo HEADPHONE JACK
headphone using a standard 1/4-inch jack to moni-
– This rotary control is used to control the
overall level of OUTPUT ZONE 1.
– High frequency equalizer rotary control
with +/-12 dB of cut or boost at 10kHz.
– Six-segment LED meter display-
ing the level of the ZONE 1 OUTPUT with -20 to +14
select either stereo or mono operation on the ZONE
– Convenient area for marking the
ZONE OUTPUT allowing you to notate the room or
area the zone is feeding.
– Low frequency equalizer rotary control with
+/-12 dB of cut or boost at 100Hz.
– ZONE 2 OUTPUT with the same
knob and switch complement as ZONE 1 OUTPUT.
– ZONE 3 OUTPUT with the same
knob and switch complement as ZONE 1 OUTPUT.
– ZONE 4 OUTPUT with the same
knob and switch complement as ZONE 1 OUTPUT.
– Use this switch to power the unit
