Setting the DVD-VCR Output Channel
Selecting the RF OUT Sound Mode (B/G-D/K)
(Newzealand Model only)
24 25
GB GB
You can rearrange the Station Table and give different programme
numbers to the stations listed according to your own preferences.
1 After pressing the MENU, press the OK or
❿ .
Result: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select the Install
option.
3 Press the OK or
❿
buttons to select this option.
Result
: The Install menu is displayed.
4 Press the corresponding
or
❷
buttons, until the Manual
Setup option is selected.
5 Press the OK or
❿
button to select this option.
Result
: The TV STATION TABLE menu is displayed.
6 Press the corresponding
or
❷
buttons, until the required preset
TV programme is selected.
Result
: The selected station is displayed at the same time on
the television screen.
7 To change the programme number assigned to a station press the
OK button on the remote control. (For example, To move a TV
station in programme 1 to programme 3)
8 Press the
or
❷
buttons to select required position.
And then press OK again to swap the position.
9 On completion, press the RETURN button four times to exit the
menu.
VCR
VCR
Changing the Preset Station Table
VCR
Your DVD-VCR output channel may need to be changed if the
pictures suffer from interference or if your TV cannot find the
pictures.
Also, you can change the DVD-VCR output channel to adjust the
frequency in which information is displayed on the screen.
1 After pressing the MENU, press the OK or
❿
.
Result
: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select the Install
option.
3 Press the OK or
❿
to select this option.
Result
: The Install menu is displayed.
4 Press the
or
❷
buttons, until the VCR Output CH option is
selected.
5 Select the required output channel (CH21~CH69) by pressing the
OK or
❿
buttons (Australia:CH28 ~ CH69).
CH28 .. CH38 .. CH69
CH21 .. CH36 .. CH69
6 On completion, press RETURN to exit the menu.
Then tune your television again (see page 16).
You can choose the sound mode (B/G or D/K) according to the TV
set connected to your VCR.
1 After pressing the MENU, press the OK or
❿ .
Result: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select the Install
option.
3 Press the OK button to select this option.
Result
:The Install menu is displayed.
4 Press the
or
❷
buttons, until the TV System option is
selected.
5
Press the
➛
or
❿
button to select G or K.
6 On completion, press RETURN to exit the menu.
G
K
