COLOR CCD CAMERA User’s Manual
33
COLOR CCD CAMERA User’s Manual
32
2. Press the Left/Right buttons to select a mode.
Off :No noise reduction
Low : Low noise reduction with almost no ghost image
Middle: Probably the most practical mode, with enough noise reduction and not too
much ghost image
High : Maximum noise reduction, but the ghost image increases as well
SETUP
CAMERA ID OFF
BACKLIGHT OFF
WHITE BAL. ATW
MOTION DET. OFF
LENS DC
SHUTTER MANUAL
AGC HIGH
SENS-UP OFF
SSNR MIDDLE
SPECIAL
EXIT
1. After the Setup menu is displayed, press the Up/Down buttons to move the arrow to
“Special.”
2. Press the Left/Right buttons to select a mode.
Privacy :Masks selected areas from the screen
- Off : Off
- On : Privacy mode is currently On
• Press the Set button
• Select an area to mask from the 4 areas in Area Sel
• Change the Area State of the selected area to On
• From Area Tone, press the Left/Right buttons to control the brightness
• Set the area size from the Top/Down/Left/Right menu, and then press the Set button.
Color :Select Color or B/W mode
- On : Always provide color images
- Off : Always provide images in B/W If you press ‘SET’, a menu will appear in which
you can turn the BURST signal ON/OFF.
By adjusting ON/OFF, you can maintain or eliminate the BURST signal.
- Auto: Use color and switch to B/W only when illumination level gets very low
- Exit : The filter can be changed by signals from external devices.
Instruction: Camera Operation
Low light noise is reduced in different ways depending on the mode; the noise reduction level
changes from none to maximum as the mode changes from Off to Low, Middle, and High.
1. After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “SSNR.”
SSNR Special
• When AGC is Off, the SSNR & Sens-Up features are not available.
Caution
