4
ASSEMBLY INSTRUCTIONS
FIGURE 2
TOOLS REQUIRED FOR ASSEMBLY
(1) Screwdriver
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrench
(2) 9/16" Wrenches
Remove the hardware pack and all loose parts from 1.
the carton. Be sure the carton is empty before
discarding.
Lay out and identify all the parts and hardware as 2.
shown on pages 2 and 3.
Place the latch lock lever through the slot in the draw bar 3.
tongue. Assemble the 5/16" x 3-3/4" hex bolt through
the tongue, lever and two 5/16" hex nuts (SEMS) (one
on each side of the lever). Assemble a 5/16" nylock
nut onto the end of the bolt and tighten so that the
bolt can still rotate freely. Tighten the two 5/16" nylock
nuts against the sides of the latch lock lever so that
the lever is centered in the slot. See figure 1.
FIGURE 3
FIGURE 1
5/16" x 3-3/4"
HEX BOLT
DRAWBAR TONGUE
LATCH
LOCK
LEVER
5/16" HEX NUTS (SEMS)
5/16"
NYLOCK
NUT
LONG END
OF SPRING
LATCH LOCK
LEVER
SPRING PULLER TOOL
3/8" x 1-1/4"
HEX BOLT
3/8" NYLOCK
NUT
HITCH
BRACKET
HAIR
COTTER
PIN
HITCH PIN
Hook the 4. short end of the spring into the hole in the
latch lock lever. Use the spring puller tool to hook
the long end of the spring into the square hole in the
tongue. The spring puller tool can be stored when
finished. See figure 2.
Assemble the end of the hitch bracket to the front of 5.
the drawbar tongue using two 3/8" x 1-1/4" hex bolt
and 3/8" nylock nut. Tighten. See figure 3.
Assemble the hitch pin to the tongue and hitch bracket 6.
and secure it with the hair cotter pin. See figure 3.
