Using the S1 DIGITAL
S1 DIGITAL | 17
Switching the headset on/off
̈ Set the Power OFF/ON switch to the position ON.
Switching the Bluetooth function on/off
̈ Switch the headset on to use the Bluetooth function.
Switching the Bluetooth function on
When switching the Bluetooth function on for the first time, the headset will
automatically go into pairing mode.
When the headset is already paired with a Bluetooth device, the Bluetooth con-
nection is automatically established. You hear a beep in the headset.
When the headset is already paired with a Bluetooth device but the Bluetooth
device is switched off or out of range, the LED flashes blue. The headset will try
for 3 minutes to connect to one of the up to 8 previously paired Bluetooth
devices. If this fails, the Bluetooth function automatically switches off after
10 minutes.
ON NoiseGard
TM
/digital is switched on. The Power LED lights up, indicating
the battery charge status or power supply via the on-board DC power
supply system.
OFF NoiseGard
TM
/digital is switched off. The Power LED goes off.
When the S1 DIGITAL, and thus NoiseGard
TM
/digital, is switched off, it can
be used as a conventional, passive headset.
̈ Press and hold the multi-function button until the
LED flashes blue. You hear an ascending beep.
