11
Basic Operation (Continued)
Changing Channels
You can select channels using Channel Select or CH ( )/( ).
•
To handle the increasing number of channels available, this
LCD TV set allows you to select up to 100 positions (Channels
0 to 99). One-digit and two-digit methods of selection can be
used. Follow the procedure shown below to select channels.
■ Using Channel Select
To select a one-digit channel (e.g., Channel 5):
Press 5 of Channel Select.
If “5-” is indicated and the picture does not change,
press
-/-- to switch over to the 1-digit select mode
and press 5 of Channel Select.
To select a two-digit channel (e.g., Channel 15):
Press -/-- to set the 2-digit select mode.
Press 1 of Channel Select.
Press 5 of Channel Select.
• Complete this procedure within 4 seconds, otherwise the selection
will not be made.
Changing channels with CH ( )/( ) on the remote
control.
Press CH ( ) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .
■ Using
AA
AA
A (Flashback)
● Press
AA
AA
A to switch the currently tuned channel to the
previously tuned channel.
● Press
AA
AA
A again to switch back to the currently tuned
channel.
Sound Volume
■ To adjust the volume
● Press VOL (+) to increase the sound volume.
The numerical value increases.
● Press VOL (–) to decrease the sound volume.
The numerical value decreases.
■ To mute the sound
● Press
ee
ee
e (Mute) to temporarily turn off the sound. The
MUTE mark is displayed on the screen.
● Press
ee
ee
e (Mute) or VOL (+)/(–) to turn the sound back to
the previous level. MUTE is automatically cleared when
one of the following buttons is pressed: POWER,
VOL (+)/(–) or
ee
ee
e (Mute).
1
1
2
2
3
LC-22GA3MX_E_P10-11.p65 04.8.25, 7:48 PM11
