16
Inspection and Maintenance
Item What to Do Daily Weekly Monthly As Req’d
Air Cleaner Clean ✔
Cut-off Wheel Check & Sharpen ✔
Bolts/Screws Check & Retighten ✔
Fuel Cap Check Leakage ✔
Fuel Tank Check Leakage ✔
Wheel Guard Check Function ✔
Clutch Bearing Grease ✔
Belt Check and Adjust ✔
Spark Plug Check and Clean ✔
Cylinder Fins Clean ✔
Fuel Filter Clean ✔
Carburetor Adjust ✔
Inspection and Maintenance Requirements
Figure 19
5. Making sure that the drive belt is
fully engaged in the drive pulleys,
slide the belt cover on and install
the two socket-head bolts into the
left-hand side of the mounting
surface only until the bolts bottom
on the belt cover. See Figure 19.
6mm Socket-
Head Bolts
Figure 20
6. Adjust the tension screw until the
tension indicator is in the middle of
the scale. See Figure 20.
7. Tighten the two mounting bolts
securely.
8. Reconnect the main water line,
adjust and retighten water nozzles
(if equipped with a water kit).
9. Reinstall the cutting wheel.
Reversing cutting head for flush cutting operations (cont.)
MAINTENANCE, REPLACEMENT, OR REPAIR OF EMISSION CONTROL
DEVICES AND SYSTEM MAY BE PERFORMED BY ANY REPAIR ESTABLISH-
MENT OR INDIVIDUAL. HOWEVER, WARRANTY REPAIRS MUST BE PER-
FORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHIN-DAIWA
KOGYO, LTD. AND USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFOR-
MANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE
EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A
BEARING ON THE OUTCOME OF THE WARRANTY CLAIM.
