A-5
Teledyne Analytical Instruments
Percent Oxygen Transmitter Appendix
NOTE: The oxygen sensors are sealed, and under normal circumstances, the contents
of the sensors do not present a health hazard. The following information is
given as a guide in the event that a cell leaks.
Protective clothing: Rubber gloves, chemical splash goggles.
Cleanup procedures:Wipe down the area several times with a wet paper towel. Use a
fresh towel each time.
Protective measures
during cell replacement:Before opening the bag containing the sensor cell, check the
sensor cell for leakage. If the sensor cell leaks, do not open
the bag. If there is liquid around the cell while in the instru-
ment, put on gloves and eye protection before removing the
cell.
Disposal: Should be in accordance with all applicable state, local and
federal regulations.
NOTE: The above information is derived from the MSDS provided by the manufacturer.
The information is believed to be correct but does not purport to be all inclu-
sive and shall be used only as a guide. Teledyne Analytical Instruments shall
not be held liable for any damage resulting from handling or from contact with
the above product.
Section VI – Handling Information
Eye Contact: Flush eyes with water for at least 15 minutes and get immediate
medical attention.
Skin Contact: Wash affected area with plenty of water and remove contaminated
clothing. If burning persists, seek medical attention.
Ingestion: Give plenty of cold water. Do not induce vomiting. Seek medical
attention. Do not administer liquids to an unconscious person.
Inhalation: Liquid inhalation is unlikely.
Section V – Emergency and First Aid Procedures
