Input selection and AV connections
19
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket. Alternatively press the external source
selection button
B
until the picture from connected
equipment is shown.
An S in the display e.g.
B
3S (EXT 3S), indicates the
input is set for an S-Video signal.
Use the Input Selection if the television does not switch
over automatically.
Input selection
PC/YUV audio
1
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
Q
until
AV connection is highlighted, then press OK.
With
S
or
R
select either AV or S-VIDEO as the
required input for EXT2.
If the colour is missing try the alternative setting.
INPUT signal selection
1
2
Press
B
to select
B
1,
B
2,
B
3 (EXT1-3),
HDMI, PC or YUV.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return totelevision mode press
B
again or
one of the numbered buttons.
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
AV Connection
PC/YUV audio No
HDMI audio Auto.
EXT2 input S-VIDEO
MENU
Back
EXIT
Watch TV
In order to receive sound from a connected PC or
component video source, plug the audio cable into the
back of the television (as shown in the ‘Connecting a
computer or component video source’ section), then
select PC/YUV audio.
In the AV connection menu highlight PC/YUV
audio. With
S
or
R
select either Yes or No.
NOTE: Selecting PC/YUV audio will force HDMI
into digital audio.
1
AV Connection
PC/YUV audio Yes
HDMI audio Digital
EXT2 input S-VIDEO
MENU
Back
EXIT
Watch TV
HDMI audio
If the connected HDMI source does not support digital
audio, plug the audio cable into the back of the television
(as shown in the ‘Connecting a computer or component
video source’ section), then use the HDMI audio settings.
In the AV connection menu press
Q
to highlight
HDMI audio. Using
S
or
R
select Auto. or
Analogue.
If the sound is missing select the alternative
setting.
1
AV Connection
PC/YUV audio No
HDMI audio Auto.
EXT2 input S-VIDEO
MENU
Back
EXIT
Watch TV
gg
