29
Function setup
General Operations
1. Press / to select Settings in home menu while in full
stop mode, the Settings menu appears.
2. Press
button, then use / button to select the setting
options.
3. Press OK button.
4. Press
or RETURN button to return to the previous
menu.
1. Press
/ to select Network in stop mode, the network
connection menu appears.
2. Press
button, then use / button to select the desired
connection setting.
3. Press OK button.
Note: The option Wireless appears only while a wireless
LAN adapter is inserted into the USB slot.
Configuring a wired Internet connection
1. Press / to select Wired, then press OK to confirm.
The IP Settings screen appears.
If the network connection is active, Link Up appears next
to Link Status. If the network connection is not active,
Link Down displays next to Link Status.
You can change the default settings to customize performance to your preference.
Network Connection Setting
2. Press / to select IP Mode, then press OK.
3. Press
/ to select an IP mode. You can select:
• Off — Disables the network interface.
• Manual — Lets you manually configure network
settings, such as IP address, subnet mask, and
gateway settings.
• Dynamic — Uses DHCP to automatically obtain an IP
address.
4. Press
or RETURN to go to the previous menu.
This menu displays the following information:
•SoftwareVersion
•SoftwareDate •NetixESN
1. In the main menu of Settings, press
button, then use
/
button to select Info to display the version information
on software and hardware.
2. Press
or RETURN to go to the previous menu.
1. In the main menu of Settings, press
button, then use
/ button to select Quick Setup, and then press OK
to confirm.
2. Press OK to perform Quick Setup.
To exit the setup menu:
•Use
button to highlight “No thanks. I’ll go through the
full setup menu later”, and then press OK.
•Orpress button directly.
3. Follow the on-screen instructions to customize the
following settings to your preference:
OSD Language Settings • •Resolution
TV Aspect•
4. After setting, press
OK to confirm and exit the setup.
Info Menu
Performing Quick-Setup
