2. PRINTER SETUP ENGLISH VERSION EO1-33058
2.2 Fitting the Fan Filter
E2- 3
2.2 Fitting the Fan Filter
2.3 Connecting the
Power Cord
When installing the printer, it is important to ensure that the Fan Filter is
attached before using the printer.
The Fan Filter consists of 2 parts:
(1) Filter Pad
(2) Filter Retainer
To fit the Fan Filter, put the Filter Pad inside the Filter Retainer and
simply press into place as shown in the diagram below, ensuring
connecting pins are aligned with the connecting holes.
1. Make sure that the printer Power Switch is in the OFF ({) position.
Connect the Power Cord to the printer as shown in the figure below
2. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
[Example of US Type] [Example of EU Type]
Filter Pad
Filter Retainer
Snap On
Snap On
CAUTION!
1.
As a Power Cord is not
supplied with the printer,
please purchase an
approved on that meets
the safety standard of
each country. (Refer to
APPENDIX 3.)
2. Make sure that the printe
Power Switch is turned to
the OFF position ({)
before connecting the
Power Cord to prevent
possible electric shock or
damage to the printer.
3. Connect the Power Cord
to a supply outlet with a
properly grounded
(earthed) connection.
Power Cord
Power Switch
Power Cord
Power Cord
