APPENDIX 4 SYSTEM MODE
EO1-33032
A4.5 Printer Parameter Fine Adjustment
A4-12
A4.5 Printer Parameter
Fine Adjustment
(Cont.)
Ribbon Motor Voltage Fine Adjustment (Feed/Rewind Motor)
With this parameter you can fine adjust the Ribbon Motor Voltage
(Torque). With “<3>ADJUST SET” displayed, press the
[PAUSE]
key
7 times to enter the Ribbon Motor Voltage Fine Adjustment (Rewind
Motor) menu.
.
To change the screen to the Ribbon Motor Voltage Fine Adjustment
(Feed Motor), press the
[PAUSE]
key again.
[FEED]
key: Pressing the
[FEED]
key once causes a –1 step
change, down to –15 steps.
[RESTART]
key: Pressing the
[RESTART]
key once causes a +1 tone
change, up to +0.
After completing the fine adjustment, press the
[PAUSE]
key.
NOTES:
1. The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter. The maximum
ribbon motor voltage fine
adjustment value is
−
15.
When the addition of values
reaches the maximum, the
value remains unchanged
even if subsequent fine
adjustments are made.
2. Each step corresponds to
5% of the standard voltage
and up to 75% of the
voltage can be decreased.
Only for the feed motor, the
voltage can be increased up
to 50%.
3. Please make this adjustment
if ribbon errors occurs
though the ribbon has not
jammed or ended.
If the problem cannot be
resolved, please contact
your nearest TOSHIBA TEC
service representative.
[RESTART]
[FEED]
Rewind Motor Feed Motor
Rewind Motor
F
M
r
Rewind Motor
