C-13
5) Others
: RX2
: Control panel parameter(Refer to 3.3.4 for details.)
: Binary/BCD input
: Communication common serial option
: Communication RS485(Refer to 6.3.2 for details.)
: Communication add-on option
[Setting procedure: Setting the parameter at for current signal(4 to 20mAdc)]
Key operated LED display Operation
The operation frequency is displayed. (Make this setting when the
motor is out of operation.)(If the monitor display mode setting
parameter is set at [Running frequency])
Press the [MON] key to call up the first basic parameter
(Automatic acceleration/deceleration).
Select by pressing the or key.
Press the Enter key to display the first parameter .
Select by pressing the key.
Press the Enter key to display the parameter setting.
Select (VI/II signal input) by pressing the key.
Press the Enter key to save the change. Then, and the
set value are displayed alternately.
MON
ENT
ENT
ENT
