TD-W8960N Wireless N ADSL2+ Modem Router User Guide
1. Add a new ATM interface and select EoA option for DSL Link Type (see 4.4.1.1
ATM
interfaces).
2. Click the Add button on the screen Figure 4-8. Select WAN Service Interface over ATM PVC
on the next screen (as shown Figure 4-9).
3. Select Bridge option for the WAN Service type on the screen (as shown Figure 4-10), and
click Next button to continue.
4. On the next screen (as shown Figure 4-14) you will see the detailed settings you’ve made.
Please click the Apply/Save button to save these settings.
4.4.2.4 ATM-PPPoA
If your ISP provides a PPPoA connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select PPPoA option for DSL Link Type (see
4.4.1.1 ATM
interfaces
).
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to PPPoE,
(see section 4.4.2.1
ATM-EoA-PPPoE). The difference is that you don’t need to set the
PPPoE Service Name and Bridge PPPoE Frames Between WAN and Local Ports on the
screen of Figure 4-11.
4.4.2.5 ATM-IPoA
If your ISP provides an IPoA connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface
1. Add a new ATM interface and select IPoA option for DSL Link Type (see 4.4.1.1
ATM
interfaces).
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to IPoE
(see section 4.4.2.2
ATM-EoA-IPoE). The difference is that you have to manually set the
Static IP Address on the screen of Figure 4-16, and the Static IP Address for DNS Server on
the screen of Figure 4-19.
4.4.2.6 ETH-PPPoE
If your ISP provides a PPPoE connection and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2
ETH interfaces.
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to PPPoE
over ATM interface (see section 4.4.2.1
ATM-EoA-PPPoE). The difference is that you have to
set the 802.1P Priority and 802.1Q VLAN ID on the screen as shown below (corresponding
screen see Figure 4-10).
27
