© Copyright 2011 TRENDnet. All Rights Reserved.
TEW-711BR
TRENDnet User’s Guide
How to add static routes to your router
Routing > Static
You may want set up your router to route computers or devices on your
network to other local networks through other routers. Generally,
different networks can be determined by the IP addressing assigned to
those networks. Generally speaking and for the case of an example, your
network may have 192.168.10.x IP addressing and another network may
have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to
communicate between the two separate networks, routing needs to be
configured. Below is an example diagram where routing is needed for
devices and computers on your network to access the other network.
Note: Configuring this feature assumes that you have some general
networking knowledge.
1. Log into your router management page (see “How to access your
router management page” on page 11).
2. Click on Routing, and click on Static.
3. Review the static route settings.
Network Address – Enter the IP network address of the
destination network for the route.
(e.g. 192.168.20.0)
Network Mask – Enter the subnet mask of the destination
network for the route.
(e.g. 255.255.255.0)
Gateway Address – Enter the gateway to the destination network
for the route.
(e.g. 192.168.10.2)
Interface – Click the drop-down list and select the Interface on
your router where the route is active.
(e.g. LAN)
Metric – Enter the metric or priority of the route. The metric
range is 1-15, the lowest number 1 being the highest priority. (e.g.
1 )
