8s
GOES BACK TO THE BEGINNING OF
THE ADVANCED SETTINGS
THERAPY ADVANCED PROGRAMMING INSTRUCTIONS
DO NOT ENTER THIS SECTION UNLESS INSTRUCTED BY A QUALIFIED TECHNICIAN
** IMPROPER CHANGES MAY CAUSE MALFUNCTION OR DAMAGE YOUR SPA AND MAY VOID THE WARRANTY! **
ADVANCED FEATURES SETUP
To exit programming mode, press , or at any point in the sequence or wait for 10 seconds (without
pressing any button).
A1. SETUP ("SU") .................................................................
While the display shows “SU” enter the Advanced Programming Menu by holding
down for 8 seconds.
A2. PUMP SETUP...................................................................
The Therapy side of the xStream Duo Pro should be set to “P=1” ONLY.
Changing this setting will cause the pump to follow button commands incorrectly.
A3. POWER SERVICE LEVEL ..................................................
The Therapy side of the xStream Duo Pro should be set to “S=0” ONLY.
This indicates that the heater will shut off when the pump is turned on high
speed.
Warning! Changes to this setting may cause inadvertent breaker
tripping and strain your power connections. If so, this would
void your warranty.
A4. COUNTRY CODE ..............................................................
This setting is not applicable to the Therapy Control.
A5. AUX BUTTON (BLOWER).................................................
This setting is not applicable to the Therapy Control, but should be left at b=-.
A6. PRIME CYCLE AT STARTUP .............................................
This step, if present, turns the pump on for a minute or two every time power is
applied to the spa, to prime the pump.
Default setting is “Pr= -”.
To exit programming mode, press
, or at any point in the sequence or wait for 10 seconds (without
pressing any button).
PAGE 9
