7.
8.
9.
10.
11.
12.
13
14.
LOCATE AS FAR
FROM HOOD AS
POSSIBLE
FIG. 4
YRAIN CAP
‘ER
IF RAIN CAP HAS
A DAMPER, REMOVE
DAMPER BLADE
FROM HOOD.
VERTICAL VENTING
7” ROUND
FIG. 5
Remove the hood and start all four screws in the center of
the narrow neck of the keynole slot marked on the cabinet
bottom. See Figure 3.
Remove proper venting knockout. If 7” (17.8 cm) round
vertical venting, entire top knockout including rectangular
portion must be removed The best performance from your
hood, with most air taken from the kitchen and when the
hood is most quiet, comes when you top vent with 7” round
duct pipe as shown in Figure 4.
FOR RECTANGULAR VENTING: There are predrilled
holes on hood so you can attach damper to hood with
small sheet metal screws included.
Install proper ductwork. For round vented installations, a
round damper should be placed in the ductwork to prevent
air infiltration.
Lift the hood into position simultaneously feeding the
electrical wire through the knockout.
Tighten four mounting screws to secure hood to cabinet.
Be sure the screw heads are in the narrow neck of the
keyhole slot.
Complete electrical wiring in the junction box according
to the National Electrical Code and applicable local codes,
Replace junction box cover
Seal holes around ventilating pipe and wiring passing
through ceiling or outside wall with caulking or insulation
to prevent heat loss.
FOR VENTLESS
INSTALLATION
1. To convert your range hood to ventless, remove the
discharge grill shown in Figure 7 by pulling with fingers.
Remove the metal back seal from behind the louver.
2. Replace discharge grill and secure with plastic rivets by
pushing with thumb.
3. Follow instructions under “Vented Installations” for wiring
and mounting. .Omit ductwork preparations.
4. Install charcoal filter from ventless kit
behind aluminum
filter.
(See Figure 8).
VERTICAL VENTING
~~‘x IO” RECTANGULAR
IF RAIN CAP HAS IF RAIN CAP HAS
A DAMPER, REMOVE A DAMPER, REMOVE
DAMPER
BLADE DAMPER BLADE
FROM HOOD. FROM HOOD.
FIG. 6
HORIZONTAL VENTING HORIZONTAL VENTING
rDlSCHARGE GRILL rDlSCHARGE GRILL
FIG. 7
