Electronic display
pad
(P. 11)
pad
, (P. 1Qll)
l
When you first plug in the range, the display
flashes time-of-day. If, after you set the clock
(see “Setting the clock” section), the display
flashes, your electricity was off for a while. Reset
the clock.
l
When showing the time of day, the display will
show the hour and minutes.
l
When you are using the timer, the display
will show seconds for time less than 1 minute,
minutes for time less than 1 hour, and hours
and minutes for time over 1 hour. The timer
indicator will be lit when in the timer mode.
1.
Press CLOCK. The colon flashes during
clock programming.
PRESS
0
CulCK
YOU SEE
2. Set the time.
PRESS
YOU SEE
Press the “up” (A) or “down” (V) pad(s) until
the correct time shows on the display.
0
A
NOTE: Press a pad briefly to change time by a
small amount. Press and hold a pad to change
time by 10 minute increments.
_-~“,x-~x_^I x,------
I-Y,--II-~IIx^I
~,-___x__________---x__ll____l*______lll__
3. Press CLOCK again to start the clock. The colon
PRESS
YOU SEE
stops flashing when the clock is active.
0
ClmK
10
