Filter
Top Products
Manual 2100-422
Page 7
WIRING
FACTORY WIRING
All units are fully factory wired. Multispeed blowers
are factory wired on high speed for cooling/manual fan
operation. Heating speeds are wired for the largest
input and may need lower speed for field installed low
input nozzle. If replacement wire is necessary, use 105
degrees C minimum. See electrical data, Table 3.
FIELD WIRING
All wiring must conform to the National Electrical
Code and all local codes. A separate fuse or breaker
should be used for the furnace.
TABLE 3
ELECTRICAL DATA
ledoMHP-ZH-stloV
latoT
spmA
rotoMrewolBrotoMrenruB
muminiM
tiucriC
yticapmA
emiT.xaM
esuFyaleD
RCAHro
rekaerBtiucriC
PHALFPHALF
E63D580HF1-06-5112.93/15.77/17.15151
E84D011HF1-06-5112.212/15.017/17.16102
E06D011HF1-06-5112.414/35.217/17.19102
E63D580FLF1-06-5113.713/16.57/17.15151
E63D580RLF1-06-5113.713/16.57/17.15151
E84D011FLF1-06-5112.212/15.017/17.16102
E84D011RLF1-06-5112.212/15.017/17.16102
E06D001FLF1-06-5112.414/35.217/17.19102
E06D001RLF1-06-5112.414/35.217/17.19102
E06D041RLF1-06-5112.414/35.217/17.19102
E63D580CF1-06-5113.73/16.57/17.15151