Filter
Top Products
tors on the rear of the units. Remember the Male XLR connector
is the input and the Female XLR connector is the output. The rst
unit in the chain (master) will use the female XLR connector only.
The last unit in the chain will use the male XLR connector only.
For longer cable runs we suggest a terminator at the last fixture.
2. Select a MB DMX to be the “master” unit. Locate the dipswitches
on the side of the unit and flip dipswitch 10 to the “on” position.
3. Follow the chart on page 14 to select a desired rotation speed
and direction. Be sure to note that this selection will be universal
throughout all motors in the chain.
4. For all other motors in the chain (slaves) located the dipswitches
on the side of the units and be sure dipswitch 10 is in the “off”
position.
5. Connect main power to all the motors and they will immediately
begin to rotate to the presets of the “master” unit.
6. The optional MINI/C Blackout Controller may be used with this
function for to stop motor rotation.
Universal DMX Control: This function allows you to use a univer-
sal DMX-512 controller such as the American DJ® DMX Operator™ or
Show Designer.™ to control rotation speed, rotation direction, and the
built-in power sockets (usually for lamps). Operating through a DMX
controller allows you the freedom to create unique and customized
programs tailored to your specific individual needs.
1. The MB DMX™ uses two DMX channels. Channel one controls
power sockets located on the side of the unit. Channel two
control the motor’s rotation speed and direction.
2. To control your motor in DMX mode, follow the set-up procedures
on pages 7 - 9 as well as the set-up specifications that are included
with your DMX controller.
3. Use the DMX controller’s faders to control the various DMX fixture
traits. A list of the traits is located on page 13.
4. This will allow you to create your own programs.
5. When using a DMX controller and setting up for DMX operation
follow the DMX addressing procedure in your controller’s manual.
All fixtures must follow a specific DMX addressing protocol for
proper operation in DMX mode.
6. For help operating in DMX operation consult the manual included
with your DMX controller.
7. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
Mounting: The MB DMX™ ships with a built-in rigging point and
two large holes in the base of the unit (that are to be used for safety
cables). The rigging point is located on the bottom of the unit. This rig-
ging point is secured to the xture by two large Phillips screws. When
the rigging point is not to be used and when the xture is shipped
from the manufacture, the point is shipped inverted (inside the bottom
of the unit). When the xture is to be hung by truss or other means,
please use the rigging point and secure the xture with safety cables.
Always be sure to rmly secure the rigging point to the unit. The MB
DMX ™ is to mounted in bottom-up position to a ceiling or may hung
from truss using a C-Clamp rated at 50 pounds or greater.
This unit is equipped with a built-in safety breaker. This breaker is
designed to close the power circuit in the event of an internal short
or power surge. This will reduce the risk of electrical shock or re and
protect the circuitry. To reset the breaker, push the breaker button in
until you hear it “pop” back in to place. If the breaker continues to pop,
stop using the unit and contact our customer support team, the unit
may need to be returned for service.
©American DJ® - www.americandj.com - MB DMX™ Instruction Manual Page 12©American DJ® - www.americandj.com - MB DMX™ Instruction Manual Page 11
MB DMX™ Operation MB DMX™ Operation
MB DMX™ Breaker Reset
MB DMX™ Mounting