Filter
Top Products
7
1. Turn off the printer.
2. While holding down the load/eject button, turn on the
printer. Then release the buttons.
3. A page prints out showing the ROM version and a
multicolor nozzle check pattern consisting of staggered
horizontal and straight vertical lines. When it’s finished,
turn off the printer. If you have any problems with the test,
see Chapter 6 in your User’s Guide for more information.
Check the Printer
Note:
The printer is assigned to
parallel port LPT1; if you
want to use a different
port, see your Windows
®
documentation for
instructions.
Connecting to a PC
ground
wire
Connect the Printer to Your Computer
3. Connect the other end of the cable to your computer’s
parallel port and secure it as necessary.
1. Turn off the printer and your computer.
2. Connect the cable to the printer’s parallel interface; then
squeeze the wire clips together until they lock in place. (If
your cable has a ground wire, connect it now.)
You can connect your EPSON Stylus COLOR 600 to either an
IBM
®
compatible PC or an Apple
®
Macintosh
®
. You’ll need a
shielded parallel cable to connect to a PC or an Apple System
Peripheral-8 serial cable to connect to a Macintosh. For a
complete list of system requirements, see the Introduction of
your User’s Guide.
Fiji Quick setup Rev.1 5/22/97, 10:15 AM7