Filter
Top Products
Operating Instructions
23
Starting the Wash Programme
0 1. Ensure that when the dishes and cutlery are loaded in the dishwasher
the spray arms are free to rotate.
2. Open the water tap fully.
3. Close the dishwasher door.
4. Turn the programme switch clockwise to A
or B (see “Programme
Table”).
1
For reasons of interference suppression, only operate the programme
switch with the dishwasher switched off. The automated addition of
detergent could also be triggered.
5. Turn the programme selector to the required programme (see “Pro-
gramme Table”).
The selected wash programme will start. The programme switch rotates
during the wash programme and indicates the position that has been
reached in the programme.
1
If a wash programme has been started but the tap was closed, turn the
programme selector to the I position, open the tap and start the pro-
gramme again.
Changing/Interrupting the Wash Programme
3
Only change or interrupt a wash programme in progress if it is abso-
lutely necessary. When the appliance is closed again, the air that has
entered is heated rapidly and expands. As a result water may penetrate
the base of the appliance and trigger the anti-flood system.
Changing the wash programme
0 1. Turn the programme selector to the I position. The wash programme
will stop.
1
Hot steam can escape from the appliance when the door is opened.
Open the door carefully.
2. Open dishwasher door and check whether there is still detergent in the
container. Refill the container if necessary.
3. Close the dishwasher door.
4. Turn the programme switch clockwise to A
or B (see “Programme
Table”).
5. Turn the programme selector to the required programme (see “Pro-
gramme Table”). The wash programme will start.