Filter
Top Products
Operating Instructions
23
Starting the Wash Programme
0 1. Check that the dishes and cutlery are loaded into the dishwasher in
such a manner that the spray arms are free to rotate.
2. Open the tap fully.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A
, or B or C (see „ Programme
Table“).
1
For interference suppression reasons, only operate the programme
switch with the dishwasher switched off. It is also possible that the
automated addition of detergent will be triggered.
5. Turn the programme selector to the required programme (see „ Pro-
gramme Table“).
Power indicator light illuminates. The selected wash programme starts.
The programme switch rotates during the wash programme and indi-
cates the position that has been reached in the programme.
1
If a wash programme has been started even though the tap was closed,
turn the programme selector to the I position, open the tap and start
the programme again.
Changing/Interrupting the Wash Programme
3
Only change or interrupt a wash programme in progress if it is abso-
lutely necessary. When the appliance is closed again, the air that has
entered is heated rapidly and expands. This can cause water to escape
onto the floor and possibly trigger the anti-flood system.
Changing the wash programme
0 1. Turn the programme selector to the I position. Power indicator light
goes out, wash programme stops.
1
Hot steam can escape when the door is opened. There is a risk of scold-
ing! Open the door carefully.
2. Open dishwasher door and check whether there is still detergent in the
container. Refill the container if necessary.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A
, or B or C (see „ Programme
Table“).
5. Turn the programme selector to the required programme (see „ Pro-
gramme Table“). Power indicator light illuminates, wash programme
starts.