Filter
Top Products
Operating Instructions
28
Changing the programme after the start delay has been set:
As long as the programme has not started, you can still change the pro-
gramme set by pressing a programme button.
0 1. Press the button for the new programme and hold it down.
First the indicator for the programme that has just been selected will
flash.
After several seconds only the indicator for the new programme will be
flashing.
2. Release the programme button.
The newly selected programme will start automatically following a
countdown of the hours set.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower basket, an intelligent electronic system
adjusts the amount of water and the duration of the wash programme
to the number of dishes. By this means it is possible to wash only a few
dishes quickly and economically. At half load (6 place settings), up to
2 litres of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Switch the dishwasher off when the multi-display indicates "0" for the
remaining programme time.
0 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes.
1
Hot steam may escape from the appliance when opening the door
immediately after the end of the programme.
2. Open the door carefully, as steam may escape.
Emptying the Dishwasher
3
• The dishes should be allowed to cool down before removing them
from the appliance, as hot dishes can be sensitive to knocks.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• First empty the lower basket, and then the upper basket. This will
avoid any water that may be remaining in the upper basket, dripping
onto the dishes in the lower basket and leaving water marks.