Filter
Top Products
Operating Instructions
31
...Error messages are displayed.
If any of the indicators in the control panel, as listed in the table below,
are flashing or are illuminated, you can probably rectify the fault your-
self.
After rectifying an Å10 or Å20error, press the button for the pro-
gramme that has been started. The programme will continue.
If the fault is displayed again, please contact customer service.
3
For all other errors displayed, please contact customer service, stating
the error code. (See chapter “Customer Service”).
Malfunction Possible cause Remedy
The programme indicator
for the selected programme
is flashing: error code
Å10
is displayed in the multi-dis-
play: there is no water run-
ning into the dishwasher.
The tap is blocked or furred
with lime-scale
Clean the tap
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Press the button for the
selected programme,
then cancel the pro-
gramme by pressing
RESET (see chapter:
“Starting a programme”);
clean out the filters (see
chapter: “Cleaning the
filters”).
The water inlet hose has not
been correctly laid.
Check hose installation.
The programme indicator
for the selected programme
is flashing, error code
Å20
is displayed in the multi-dis-
play.
The siphon is blocked. Clean out siphon.
The water drain hose has
not been correctly laid.
Check hose installation.
Error code Å30 is displayed
in the multi-display.
The leak prevention system
has been triggered.
Turn off the tap and
contact customer serv-
ice.