Filter
Top Products
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that
their use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used
as they may dull the surface finishes. Harsh
abrasives and scourers should also be avoided as
damage will occur.
CLEANING THE OUTSIDE OF THE
OVEN
Regularly wipe over the control panel, oven doors
and handles using a soft cloth and hot soapy
water. To prevent streaking finish with a soft cloth.
Model D4100-1M/A only
Stainless steel cream cleaners can be abrasive
and should be avoided as damage to the surface
finish can occur. Washing up liquid and hot water
or liquid stainless steel cleaners such as Homecare
Stainless Steel Cleanser and Polish may be used
to remove fingermarks.
REMOVING AND REPLACING
WIREWORK SIDE RUNNERS
Remove all shelves and furniture from the oven. If
fitted ensure the telescopic runners are pushed
back into place in the oven cavity. Hold the bottom
of the wirework runners and draw the runners
towards the centre of the oven. Unhook from the
top and remove.
The telescopic runners should be dried carefully
after washing in hot water to which washing up
liquid has been added. lf heavily soiled mild
abrasives may be used.
To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
place.
30
CARE AND CLEANING
BEFORE CLEANING THE OVEN
ALWAYS ALLOW THE COOLING FAN
TO COOL THE OVEN DOWN BEFORE
SWITCHING OFF THE ELECTRICITY
SUPPLY.
CAVITY CENTRE
BRACKET
Do not attempt to remove any of the
control knobs from the panel as this may
cause damage and is a safety hazard.
Ensure the wirework runners are firmly
in position before replacing the oven
shelves.
Under no circumstances should the
door assembly be detached from the
product for cleaning. Please refer to the
cleaning instructions.