Filter
Top Products
38
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Connecting using the supplied
cord and plug
Your range is shipped with a 4-prong plug to be
used in a NEMA 14-50R receptacle.
Plug the range power cord into a properly
grounded wall receptacle.
Connecting if the supplied cord
and plug is not suitable.
To remove the electrical connection cover fi rst
remove the screws on the bottom edge.
Slide the cover down to free the top tags.
When refi tting the cover fi rst locate it on the top
tags and then replace the screws.
.
4-Wire Conduit Installation
Disconnect the supplied power cord from
the terminal block and ground post. Keep
the terminal block parts; you will need them.
Remove the strain relief clamp from the power
cord and remove the power cord and strain relief
clamp from the mounting bracket.
The range is shipped with reducer plates to
give a 1 1/8’’ diameter opening for conduit
connection. Find the reducer plates in the
conversion kit and fi t them to the mounting
bracket.
Fit a squeeze connector (not supplied with
the range), to your conduit. Insert the conduit
through the reducer plates on the mounting
bracket. Allow enough slack to easily attach the
wires to the terminal block.
NOTE: Do not install the conduit without a
squeeze connector.
Fit the wires to the ground post and terminal
block
NOTE: Make sure the wires are completely
inserted into the terminals and secure
connections are made.