Filter
Top Products
pg. 20 TH/III InsTallaTIon/operaTIon/servIce manual (11/12)
OPERATION
Programming a Preset
Select the product to be programmed and begin programming with the oven control power Off.
Press and release control O
n/Off key. The oven will beep for one second and power to the unit
will be indicated by an illuminated green indicator light located in the upper left corner of the
ON/Off key. The oven will begin operating in the hold mode. The amber Hold indicator will be
illuminated and the last set hold temperature will be displayed.
To set Cook temperature — Press cook Key. Oven preheat indicator will illuminate and the last
set cooking temperature is displayed. To change the cook temperature, press the up or down
arrow Keys.
If cooking by time — press the
time Key. The green time indicator will illuminate and the last set
cooking time will be displayed. To change the set time, press the up or down arrow Key. The
display will alternate between the set temperature and the elapsed time.
If cooking by probe — press the
probe Key. The green probe indicator will illuminate and the last
set internal product temperature will be displayed. To change the set temperature, press the up
or down arrow Key. The display will alternate between the set temperature, the elapsed time,
and the probe temperature.
To set Hold temperature — Press the hold Key. The green cook indicator light will remain
illuminated. To change the hold temperature, press the up or down arrow Key. The display
will alternate between the set hold temperature and the amount of time the product has been in
the hold mode. Oven will remain in the hold mode until the oN/off key is pressed.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
preset key for two seconds. When the preset has been saved, you will hear a one second beep and the
preset light will illuminate.
Note: Only one preset can be programmed at a time. If programming an additional preset is
desired, the unit must be started and stopped either by cycling the power to the cavity or by
pressing the Start/Stop key. The last preset Key used will be the oven cooking run sequence
for the next product to be programmed. Settings can be manually changed for the next
product and an alternate pre-programmed letter key selected.
Erasing a Preset
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a preset Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold the cancel Key and
then the appropriate letter preset Key to be erased for two seconds. When the preset has been erased the
oven will beep for one second.
IMPORTANT - After programming a specific product into memory in a programmable
preset key, it is very important to make a written permanent record of the product and the
program letter assigned. Menu card (PE-23384) is provided for this purpose.