Filter
Top Products
TH/III InsTallaTIon/operaTIon/servIce manual (11/12) pg. 21
OPERATION
USER OPTIONS
PreseT Keys Lock and Unlock
preset Keys A through H can be locked in order to
prevent storing, altering or erasing a program.
To lock the Preset Keys, press and hold the “I”
Key until the oven beeps. Release the “I” key. The
green indicator on the “I” key will illuminate. Oven
preset Keys A through H are now locked.
Note: Only the oven preset keys A through H are
affected by this lock-out in order to also allow
the oven to be used with the unprogrammed
Cook, Probe, or Hold modes.
To unlock the Preset Keys, press and hold the
cancel Key along with the “I” Key for two seconds
until the “I” key light no longer illuminates. Release
all keys. The oven preset keys are now unlocked.
Fahrenheit or Celsius Selection
With the control in the off mode,
press and hold the up arrow Key until
the display shows the current selection.
Press the up or down buttons to toggle
between the two options. After each
change the button must be released. The
display must clear before the procedure
can be repeated.
Control Panel Lock and Unlock
The control panel can be locked at any time in order to
prevent inadvertent or accidental setting changes.
To lock the control panel, press and hold the
up arrow Key and then press the ON/Off Key.
You will hear a brief beep and the panel lock
indicator will illuminate. Release all keys.
The oven’s control panel is now locked.
Note: The control panel is now fully locked with the
exception of the ON/Off Key and arrow keys.
You will be unable to turn the oven control off at
this point.
To unlock the control panel, press and hold the down
arrow Key and then press the ON/Off Key. You
will hear three beeps and the panel lock indicator will
extinguish. Release all keys. The panel is now unlocked
and ready for normal use.
Beeper Volume Selection
With the control in the off mode, press
and hold the down arrow Key until
the display shows one of the 4 volume
levels (0 being off or the lowest, and
3 being the highest). After each change,
the button must be released and the
display must clear before the procedure can be
repeated to select a different volume level.
Turn the unit on and then off again to store the
desired set point.